WIFI Configurable Animation Que With any Phone/Tablet
Easy push button control with 3 brightness levels
Latest Video:
Work In Progress Videos:
- https://www.instagram.com/p/CdhK-MJlzfi/
- https://www.instagram.com/p/CdkwEaLFQ3Y/
- https://www.instagram.com/p/Cdk7ihlFeke/
Ready made and available to ship ASAP!
This mask is made from the base of a polymer & metalic mesh airsoft mask. It is supported on your face/head with a fully adjustable quad elastic connector. Its covered in 412 Addressable SUPER BRIGHT Full Color LED pixels, diffused with Wonderflex. The piece is intended for an adult face. The mask has a tiny controller module that is held in place, on the elastic strap, by a sewn in velcro strap. The controller has a 1.5m USB cable that connects to your power bank battery.
There is a single push-button on the rear that allows you to toggle between 3 brightness levels & to configure the animation que using your phone/tablet
The controller is powered by a standard USB plug which needs to run of a Mobile Power Bank(see power requirements below)
Power Requirements:
You must BYO a battery because I can not ship them in the mail. This model has been tested and is recommended BUT any power bank with a 2A output port will work just fine
Cygnett - https://www.cygnett.com/products/chargeup-digital-10-000-black-grey-powerbank
Animation + Brightness control modes:
This model is pre-loaded with 28 animation sequences that run for 5 seconds each (this is the default Que)
You can also configure the mask to run ANY animation sequence for ANY duration of time per animation, via a web interface:
- With the mask powered OFF, HOLD DOWN the push button the back of the mask and power on the masks power switch
- Count to 3 and the mask will now boot into configuration mode (no lights will light up on the mask just yet)
- On your phone/tablet open your WIFI settings and connect to the network named "WOW_APP" using password "wowaccesspoint" Once connected your device may advise you that there is no internet, ignore this message and continue to connect to it
- Open your phones web browse and go to the following wed address HTTP://10.10.10.1
- The masks configuration page will load:
- The INDEX column indicates the index this animation has in the que (I suggest keeping your que to under 1000)
- The Animation column has a drop-down that allows you to choose what animation you want at that position
- The Duration column allows you to set this animations run time in SECONDS from 1 to 255 seconds
- The last column with the red X, allows you to REMOVE this animation from the que
- At the bottom of the page you can push the "+ Animation" button to add another animation to the que
- Once you are happy with your animation que hit "Save to ESP" and the mask will boot up
YOU MUST HAVE AT LEAST 1 ANIMATION IN YOUR QUE OR THE MASK WILL RESET ITSELF TO ITS DEFAULT QUE
This mask was hand made by me to the highest possible standard. All of my wearables have been torture tested at music festivals and large crowds :)
Shipping:
I use 2 flat rate express shipping methods from Australia. 4 to 6 Business day overseas express and 3 Day DHL Overseas Express. You can also select 5-10 Business day standard overseas parcel. For all Australian customers, I use Australia Post Express Post. You can choose your shipping method at checkout. I ship out 24 hours after payment has been made.